StopTech ST-40 Caliper Скачать руководство пользователя страница 3

Страница: 3 / 25

APPLICA

APPLICATION DISCL

TION DISCL

TION DISCLAIMER

AIMER

Caliper Clearance

Most 17” wheels will clear the outer diameter of the caliper for a 328mm or 332mm rotor kit. For a
355mm kit, a minimum 18” wheel is typically required, and for a 380mm rotor kit, a minimum 19”
wheel is needed. The more critical clearance, however, is the gap between the spokes of the wheel
and the face of the caliper. Do not assume that a larger-diameter wheel will automatically clear the
face of the caliper.

To determine the actual metal-to-metal distance from the stock rotor face to the inside of the wheel
spokes, refer to the StopTech website at www

www

www.stoptech.com

.stoptech.com

.stoptech.com, and click on the ‘Wheel Fitment’ link

in the ‘Technical Information’ section. Review the instructions carefully, to ensure that you have a
full understanding of how to accurately measure the critical wheel clearances.

It is very important that you verify the accuracy of the scale of the printout by matching both a
width and length dimension on your vehicle. Dimensions are shown in millimeters, but one di-
mension in each direction is also shown in inches, and StopTech recommends adding at least 2mm
of additional clearance to these dimensions. Follow the instructions carefully, to produce a fitment
template, and take care to ensure that your measurements are very precise. If you have any ques-
tions or difficulties, please contact the StopTech Customer Service Department on (310) 325-4799 -
extension 105, or send an e-mail to [email protected]

[email protected]

[email protected].

Note: F

ote: F

ote: Final fitment of the wheel to the caliper is the r

inal fitment of the wheel to the caliper is the r

inal fitment of the wheel to the caliper is the responsibility of the customer

esponsibility of the customer

esponsibility of the customer.....

Wheel Spacers

Wheel spacers can provide extra clearance to the outer face of the caliper. This will also space out the
entire wheel, widening the track width of the vehicle. Fender clearances should be checked on
lowered cars, and longer lug studs or wheel bolts are usually required.

Note: The Wheel Industry Council has issued guidelines advising that wheel spacers not be

Note: The Wheel Industry Council has issued guidelines advising that wheel spacers not be
used. It is the responsibility of the customer to ensure that wheel spacers are properly

used. It is the responsibility of the customer to ensure that wheel spacers are properly

used. It is the responsibility of the customer to ensure that wheel spacers are properly
specified and installed.

specified and installed.

Caliper

aliper

aliper, H

, H

, Hat and B

at and B

at and Bracket F

racket F

racket Finish D

inish D

inish Disclaimer

isclaimer

Many wheel-cleaning solutions contain strong acids that may damage the finish on any caliper or
aluminum anodized finish, especially the plating on the hardware. Check for adverse effects by
trying a small amount of the cleaner in question on an inconspicuous area. Avoid over-spraying,
and rinse cleaning solutions off as quickly as possible. StopTech is not liable for damage to calipers,
hats or bracket finishes, due to corrosive chemical exposure.

3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 3