StopTech ST-40 Caliper, Руководство по установке

Страница: 18 / 25

3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 18
S SS
SStep 6
tep 6
tep 6 tep 6
tep 6 (Cont (Cont
(Cont (Cont
(Cont’’’’’d.) d.)
d.) d.)
d.)
IIIIInstall C nstall C nstall C nstall C nstall Caliper and P aliper and P aliper and P aliper and P aliper and Pads ads ads ads ads
N N
N N Note: The bridge is dir
ote: The bridge is dir
ote: The bridge is dir ote: The bridge is dir ote: The bridge is directional, and should
ectional, and should
ectional, and should ectional, and should ectional, and should
be positioned so that the air-scoop opening is be positioned so that the air-scoop opening is be positioned so that the air-scoop opening is be positioned so that the air-scoop opening is be positioned so that the air-scoop opening is
located in the bottom half of the bridge.
located in the bottom half of the bridge.
located in the bottom half of the bridge. located in the bottom half of the bridge.
located in the bottom half of the bridge.
Install the bridge by sliding it into position, and
rocking it until one of the bolt holes lines up.
Take care to ensure that the bridge is slid straight
and parallel into the caliper body opening.
Torque each bolt to appr appr
appr appr
appro oo
o
oximately 8-10 lb-ft ximately 8-10 lb-ft
ximately 8-10 lb-ft ximately 8-10 lb-ft
ximately 8-10 lb-ft,
using a 5mm Allen wrench. Do not use a torque
wrench, as the use of anti-seize compound will
cause a false reading. Do not over-torque the
bridge bolts - snug is tight enough.
W W W W War ar ar ar arning: D ning: D ning: D ning: D ning: Do not hammer the bridge bolts o not hammer the bridge bolts o not hammer the bridge bolts o not hammer the bridge bolts o not hammer the bridge bolts
into place. T into place. T
into place. T into place. T into place. Tap the bridge, not the bolts!
ap the bridge, not the bolts!
ap the bridge, not the bolts! ap the bridge, not the bolts! ap the bridge, not the bolts!
Double-check the orientation of the bridge, to
ensure that the air-scoop opening is located in
the bottom half of the bridge.
Start the second bolt, and apply pressure to the
bridge, using the palm of your hand, or by gen-
tly tapping the bridge with a mallet, until the
bolt engages in the hole. Start the first few threads,
using a 5mm Allen wrench.
Insert the first bridge bolt, from the outside of
the caliper, and start the first few threads, using a
5mm Allen wrench.