Stonex S9i GNSS Receiver – User Manual
13
3. Then the mainframe will voice broadcast “set WIFI”. Press the F key gently,
then there will be a voice broadcast “WIFI enable” or “WIFI disable”. Press the
power key to confirm, and there will be a voice broadcast “set successfully”.
4. Finally, press the F key gently, voice broadcast the mainframe current
working mode and datalink status.
Note: It is possible to switch work mode and datalink using Web UI function.
4.4 Self-checking
If the indicators are abnormal or the receiver can’t work normally, for
example if the Bluetooth can’t be connected or the radio mode does not
work you can use the automatic self-checking functions to detect the failure.
Self-checking will check GPS, radio, GSM, Bluetooth, WIFI and sensor. This
process has voice guide reporting the status of the module.
1. When the receiver is in powered on status, press and keep the power key
until a voice broadcast “if you want to turn off the device”, then release the
power key. Keep press the power key again until you hear a beep . Now a
voice broadcast “start self-checking” , release the power key and self check
will start .
2. In the process of device self-checking, there will be voice broadcast the
test results. If the module checking is successful, voice broadcast “success”
and the led always on until the self-checking is completed. If the module
checking fails, voice broadcast “self-checking fails”, the led will continue blink
and the buzzer beeps until you restart S9i. Self-checking procedure require
about 1 minute.
3. If all module leds are ON (not blinking) and voice broadcast that the self-
checking success (for example “self-checking GPS success”), it means the
modules could work normally.
Note: After self-checking, built-in radio frequency will return to factory
settings. If necessary, please contact your local dealer to change the
frequency to match your usage.
