StoneAge NA60IND, Инструкция по установке и эксплуатации

Страница: 9 / 14

9
A. When the chimney passes through a ceiling to
an upper floor, ensure the chimney pipe manufac-
turers recommended clearances to combustibles is
maintained with framing where it passes
through
the ceiling.
B. Complete chimney installation as shown in
Figure 26. As the chimney extends through the
attic to the roof, attach securing straps to rafters and
joists as required to provide stability.
C. As the chimney rises through the ceiling, per-
haps a second floor, and through the attic and roof,
16 inches or 30 degrees is the maximum offset al-
lowed, and only one offset is permitted.
D. If chimney exit opening does not already exist,
locate the point where the chimney will exit the roof
by plumbing down to the center of the chimney.
Drive a nail into the roof to mark the center.
E. Measure to all sides of the nail and mark the
required opening, and then cut a hole in the roof.
Remember that the hole is measured on the hori-
zontal, and then projected to the roof. The hole
may then be larger, depending on the pitch of the
roof. See Figure 23.
F. Frame the opening, ensuring that the recom-
mended minimum clearance to combustibles by the
chimney pipe manufacturer exists between the roof
and the chimney, ensuring that distance is main-
tained all the way around.
WARNING: DO NOT PACK REQUIRED AIR
SPACES WITH INSULATION
OR OTHER MATERIALS.
G. Continue to add pipe sections, extending the
chimney through the roof.
H. A wood chase may be constructed around the
exposed chimney for aesthetic effect. Ensure the
minimum recommended clearances to combustibles
specified by the metal chimney pipe manufacturer
are maintained inside the chase.
I. Install roof flashing appropriate to the roof
pitch, and any other pipe accessories, per the pipe
manufacturer’s instructions.
J. Install the appropriate chimney cap for the pipe
being used.
4.3 Height of Chimney – Metal or Masonry
Figure 27 illustrates the proper height of the chimney
top. Correct height depends on the chimney’s loca-
tion on the roof and distance from the peak of the
roof. Surrounding trees, other buildings and hills
may also be a consideration.
Figure 26. Metal Chimney Construction
Figure 27. Chimney Height