Stone SAW DEVIL CS1, Руководство оператора

Страница: 20 / 32

- 20 -
Operation
Figure 1 cs002a
Dry Cutting
6. To check alignment, use a steel straight edge.
See Figure 1.
7. Line up the straight edge along the outside
face of both pulleys shown in the drawing.
All pulleys have (2) set screws in the bottom
of their grooves. Set screws require thread
locking lock tite.
8. Misalignment will show up as a gap between
the pulley face and straight edge. Make sure
there is clearance between arbor pulley and
saw base on both sides.
DRY CUTTING
• Never operate any saw without safety
guards in place.
• Do not exceed maximum operating speed
established for blade diameter.
• Do not force blade into material: allow
blade to cut at its own speed.
• Do not make long continuous cuts. Never
dry cut for more than 30 seconds at a time.
Allow blade to cool.
• Do not cut or grind with side of blade or
cut a curve or radius.
• Do not cut dry with blades recommended
for wet cutting.
• Do not operate saw with blade diameter
larger than machine's capacity.