Stone SAW DEVIL CS1, Руководство оператора

Страница: 18 / 32

- 18 -
Operation
Before Starting/Cold Start/Hot
Start/To Start Sawing
BEFORE STARTING
1.Use correct blade for cutting conditions.
2.Ensure arbors and collars are clean and
undamaged.
3.Mount blade and tighten securely using both
wrenches.
4.When wet cutting, check water jets for
adequate flow.
5.Disengage transmission on self-propelled
models.
6.Align pointer with saw blade.
Caution - Set unit up in an open area. Avoid
close proximity to structures or other equip-
ment. Failure to do so may cause inadvertent
injury to operator or other persons in the area.
Cold Start - Open the fuel valve under the gas
tank all the way. Position the engine stop
switch, located on the engine, to run. Open the
throttle approximately half way and apply the
choke. Pull the starter rope sharply. When the
engine starts, open the choke and adjust the
throttle as necessary to keep it running. Allow
the engine to warm up for a few minutes before
placing it under the load. If the engine doesn't
start after (3) pulls, open choke slightly to
prevent flooding. Always operate the engine at
full throttle when under load.
Hot Start - Open the valve under the gas tank
all the way if it has been shut off. Open the
throttle approximately half way. Do not apply
the choke. Pull the starter rope sharply until the
engine starts. When the engine starts, adjust the
throttle. Always operate the engine at full
throttle when under load.
NOTE: These starting instructions are general
guidelines only. Since many engine options are
available, consult the Engine Manual included
with this unit for specific instructions.
Caution - Gasoline Engines - To improve the
engine service life, allow the engine to idle
without load for (2) to (5) minutes before shut-
ting it down. When the idling period is up,
use the stop switch located on the engine and
turn it to stop. Close the fuel valve under the
gas tank. Engine flooding can occur if the
valve is left open during transport.
TO START SAWING
1.Start engine and let engine warm up. All
sawing is done at full throttle.
2.Align blade and saw with cut. If wet sawing,
open water valve and turn water safety
switch on. (CSP3)
3.Lower blade to touch surface and re-zero
depth gauge. (CS2 and CSP3 models).
4.Lower blade into cut slowly.
5.Put speed control in neutral, engage trans-
mission and move speed control lever slowly
toward forward position. (CSP3 model
only).