Stone 1050PM, Руководство по обслуживанию и запасным частям

Страница: 17 / 69

- 19 -
Maintenance
CLEANING
For consistent performance, long life and continued
high quality mixing of plaster or mortar, thoroughly
clean the mixer inside and out at the end of each
day's operation. To prevent lumps of dried plaster
from forming and contaminating future batches of
plaster or mortar, do not allow built up materials to
form on drum guards, around paddles or anywhere
inside the drum.
Before cleaning, shut off the engine or motor and
disconnect the spark plug wire or electric cord to
prevent accidental starting. Spray the mixer with
water before the mix dries to remove any
accumulations. Dried mix should be scraped out as
necessary. DO NOT beat on the drum with a
shovel, hammer or other device to break up
accumulations of dried mix, as this will dent and
damage the drum.
N
EVER
P
OUR OR
S
PRAY
W
ATER
O
VER THE
E
NGINE OR
M
OTOR
N
EVER
P
UT
H
ANDS OR ANY
O
BJECT
INTO THE
D
RUM WHILE THE
E
NGINE
OR
M
OTOR IS
R
UNNING
A
LWAYS
D
ISCONNECT THE
S
PARK
P
KLUG
W
IRE OR
E
LECTRIC
C
ORD
WHEN
C
LEANING
I
NISDE
D
RUM
A
LWAYS MAKE SURE
G
UARD
L
IFTER IS
R
ECONNECTED TO
G
UARD BEFORE
USING
M
IXER
--D
O
N
OT
O
PERATE
THE
M
IXER WITH
D
RUM
G
UARD
O
PEN
OR
R
EMOVED
TOWING
Before attempting to tow this mixer, check the state
and local laws that apply to your intended route and
check the following:
1. Hitch attached to the towing vehicle securely.
2. Towpole fully extended and bolted to mixer
securely.
3. Safety chain hooked up properly (see
illustration below or decal on mixer front post).
4. Drum in the mixing position and drum latch
engaged, clutch lever in the UP position.
5. Lug nuts and axle mount nuts tight.
6. On extendible axles, axle extended to full width
and adjustment bolts tight.
7. On spring axles - spring mounting hardware
tight, main springs and snubber springs not
cracked or broken.
Cleaning/Towing