Stone Age NA48, Инструкция по установке и эксплуатации

Страница: 3 / 14

3
Note 5: Ensure installation complies with local building
codes.
2.2 Installation of Additional Equipment
WARNING: THIS FIREPLACE HAS NOT
BEEN TESTED FOR USE WITH
DOORS. TO REDUCE THE
RISK OF FIRE OR INJURY, DO
NOT INSTALL GLASS DOORS.
A. Do not install a fireplace insert unless it is tested
with this fireplace.
B. Cutting or drilling a hole into the floor or walls
for gas supply for a vented decorative gas appliance
(log), fresh air venting, or an ash dump, is accepta-
ble.
C. If a decorative gas appliance is installed, it must
be installed in accordance with the National Gas
Fire Code, ANSI Z223.1.
D. It must incorporate an automatic shutoff device.
E. Installation must comply with the Standard for
Decorative Gas Appliances in Vented Appliances,
ANSI Z21.60 (1991) or American Gas Association
draft requirements for Gas-Fired Log Lighters for
Burning Fireplaces, Draft No. 4 dated August 1993.
3.0 Installation of the Fireplace
WARNING: DO NOT USE SUBSTITUTE
MATERIALS IN THE
ASSEMBLY, INSTALLATION
OR OPERATION OF THIS
FIREPLACE. TO DO SO WILL
VOID THE WARRANTY AND
MAY RESULT IN FIRE AND
PERSONAL INJURY.
It is most important that the Stone Age fireplace be
installed according to the following instructions. It is
also important that local building codes be consulted
and followed. Improper installation could result in:

Overheating, leading to fireplace failure

Leakage of rainwater through and around
the chimney

Cracks and settling because of poor founda-
tions

Emission of smoke, sparks and gases into
the living area

Combustion of materials adjacent to the
fireplace.
WARNING: THIS FIREPLACE HAS NOT
BEEN TESTED WITH AN
UNVENTED GAS LOG SET. TO
REDUCE THE RISK OF FIRE
OR INJURY, DO NOT INSTALL
AN UNVENTED GAS LOG SET
INTO THIS FIREPLACE.
Do not install this fireplace in a manufactured or
mobile home.
3.1 Preparations
Select a wall location in the home plans where all the
minimum distances, as shown in Table 2 and Figure
3 can be met. Proceed as follows. Numbers in ( )
are item numbers from Table 1 and Figure 2. Ensure
the base on which the fireplace is to be installed is a
solid and level foundation and is composed of non-
combustible material, such as concrete.
Select a high temperature fire clay or refractory ce-
ment and mix according to manufacturer’s instruc-
tions. Several companies in the U.S. and Canada sell
refractory cement or fire clay including Stone Age
Manufacturing.
Figure 3. Clearances (Use with Table 2)