9
T. Install the enclosure end panels (13). End panels
are larger than required, and should be field cut to
the approximate shape outlined in red. Note that the-
se do not need to be exact, as any voids will be filled
in with mortar. You may also cut into multiple
smaller pieces if needed or preferred. Mortar the
trimmed pieces into place. See Figure 26.
U. Install the oven chimney (14), smoothing the
mortar on the underside where it meets the interior of
the oven roof. See Figure 27.
V. Cut out the front corners of the roof panels (15)
to clear the oven chimney as outlined in red, approx-
imately 14” from the front, and 5” from the side.
Using the pieces cut from the roof panels, cut two
pieces approximately 5” by 4”. Mortar the main roof
panels into place, and mortar the small pieces for the
area in front of the chimney section. Note that for
increased thermal efficiency, the void between the
oven roof and the enclosure roof may be filled in
with a non-combustible insulating material, such as
vermiculite, if desired. See Figures 28 & 29.
Figure 27. Oven Chimney
Figure 26. Enclosure End Panels
Figure 28. Oven Roof
14”
14”
5”
5”
13
13
13
13
14
15
15
