STOKVIS ENERGY SYSTEMS ECONOPLATE H1, Инструкция по установке, наладке и обслуживанию

Страница: 14 / 15

13
12. APPENDICES
Table 1 – Electronic Box Wiring Denotation
Description Individual Wiring Connector
Remote Controller/Temperature
Sensor
2 Black Wired to Relay via NO
contacts
Mixing Valve Stepper Motor Blue, Black, Brown and Green White Connector
Mains Cable Blue, Brown and Green/Yellow Wired to Terminal Block
Earth Cable Green/Yellow Non insulated Crimp Ring
Pump Blue, Brown and Green/Yellow Wired to Terminal Block
CH Temperature Sensor 2 Red Black Connector
CH Safety Thermostat/Pressure
Switch
2 Black Not used ‐ connected
together
Table 2 – Electronic Box Dip Switches
SWITCH FUNCTION ON OFF
1 High temp / Low temp central
heating
Low temp High temp
2 H1 Heating only Heating only [needs DIP
switch 4 on as well]
Not required
3 N/A N/A Correct
4 Single plate / Twin plate Twin Single
5 DHW preheating Enabled Disabled
6 DHW sensor Flow meter Flow switch
N.B Switch 3 should always be in the off position, otherwise unit will not work. If in doubt do
not make any changes.
Table 3 – Matrix LED
ANOTATION COLOUR LIGHT OFF LIGHT ON LIGHT FLASHING
ON Green Power Off Power On N / A
HEAT Yellow No Heat Demand In Heat Mode N / A
FAULT Red No Fault CH Saftey wire
faulty Sensor fault – replace
failed NTC temperature
sensor