Stoelting E131I, Руководство пользователя

Страница: 19 / 37

11
I. The freezer is designed to dispense the product at a
reasonable draw rate. If the freezer is overdrawn, the
result is a soft product or a product that will not
dispense at all. If this should occur, allow the freezer
to run for approximately 30 seconds before dispens-
ing additional product. After a while the operator will
sense or feel when the freezer is beginning to fall
behind, and will slow down on the rate of draw so as
not to exceed the capacity. Spigot Rate Adjusters are
located under the Header Panel, to the immediate
right of each Spigot Handle. Turning the Spigot Rate
Adjuster counterclockwise will decrease the
dispense rate.
J.
Do not
operate the freezer when the MIX LOW
message is displayed or with less than 1-3/4" (4.4
cm) of mix in the hopper. Refill the hopper
immediately.
NOTE
The freezer has a standby and sleep mode. When
the freezer is not used, after a preset number of
freezing cycles, it will enter the standby mode
(followed by sleep mode) and remain there until
someone draws a product or pushes the push-to-
freeze switch. In the sleep mode, the freezer will
keep the product below 45°F (7.2°C). Sleep modes
are not to be used in place of cleaning and sani-
tizing. Frequency of cleaning and sanitizing is
determined by Federal, State, and local regula-
tory agencies.
Figure 14. Dispensing Product
3.5 MIX INFORMATION
Mix can vary considerably from one manufacturer to
another. Differences in the amount of butterfat content
and quantity and quality of other ingredients have a
direct bearing on the finished frozen product. A change
in freezer performance that cannot be explained by a
technical problem may be related to the mix.
When changing from one type of mix to another such as
yogurt to Vitari, you may have to change the mix inlet
regulator and/or control settings. Please call your
distributor for further information.
Proper product serving temperature varies from one
manufacturer’s mix to another. Mixes should provide a
satisfactory product in the 18° to 20°F (-7° to -6°C)
range.
When checking the temperature, stir the thermometer in
the frozen product to read the true temperature.
Mix
does not
improve with age. Old mix, or mix that has
been stored at too high a temperature, can result in a
finished product that is less than satisfactory in taste
and appearance. To retard bacteria growth in dairy
based mixes, the best storage temperature range is
between 36° to 40°F (2.2° to 4.4°C).
Some products tend to foam more than others. If excess
foam should occur, skim the foam off with a sanitized
utensil and discard. Periodically, stir the mix in the
hopper with a sanitized utensil.
3.6 REMOVING MIX FROM THE FREEZER
To remove the mix from the freezer, refer to the following
steps:
A. Remove the mix inlet regulator from the hopper by
pulling straight up (Fig.15).
Figure 15. Removing Mix Inlet Regulator