15
CAUTION
DO NOT PLACE THE MIX INLET REGULATOR
INTO THE HOPPER BEFORE INSTALLING THE
AUGER.
E. Install the two plastic flights onto rear of the auger
and insert part way into freezer barrel.
F. Install the remaining plastic flights, push the auger
into the freezer barrel and rotate slowly until the
auger engages the drive shaft.
G. Install the auger support and bearing into the front
of the augers with one leg of the support at 9 o’clock.
NOTE
Apply a small amount of Petro-Gel to the surface
of the cam on the spigot handle prior to assembly
of handle to the spigot body.
H. Install the spigot bodies with ”O” Rings into the front
door from the bottom (Fig. 28). Push straight up until
the spigots are in place. Install rosette cap.
I. Install the front door on the freezer.
J. Install the circular knobs on the freezer studs.
Figure 27. Exploded View of Auger
Figure 28. Exploded View of Front Door
CAUTION
FINGER TIGHTEN THE CIRCULAR KNOBS
EVENLY. DO NOT OVERTIGHTEN KNOBS.
Look for the proper seal between the freezer barrel, “O”
Ring, and front doors.
K. Install the mix inlet regulators into the hopper with
the air inlet (long) tube toward the front of the freezer
(Fig. 29).
