Due to continuous product research and development,
the information contained herein is subject to change without notice.
Page 18
www.stoddart.com.au
Rinse Riser and Anchor Installation
Electrical Connections
Plumbing Connections
Follow the faucet manufacturer’s directions on the assembly of the faucet and riser� Anchor the riser supports to the wall using the flange plate
provided with the riser assembly� It may be necessary to cut the support rods to a shorter length in order to fit between the wall and the riser�
The final electrical connections between the Power Soak and the electrical supply must be made by a licensed electrician� The Power Soak
has several options for motors and heater� Review the information tag for determining the specific requirements of the machine being installed
(see Verify the Electric Requirements section of this instruction booklet)�
Connect the water supply lines to the faucet� Connect all the drains to the waste drain connection�
Complete the connection
of all drains and water
supply lines
Cut the riser support rods
to the proper length and
attach flanges to the wall
Installation
Installer is responsible for all plumbing
to confirm to local building codes which
may be different from illustrations shown
in this manual
IMPORTANT
