Due to continuous product research and development,
the information contained herein is subject to change without notice.
Page 10
www.stoddart.com.au
Assembly
Component Assembly
Install Sink Drains
Lay the sink on its back to allow access to the bottom of the tanks� Be careful to not let the sink assembly drop on the floor with an impact
that would damage the sink assembly or the floor� It may be necessary to place some cardboard or tarp on the floor to protect the finish�
The sink must be accessible from its top side and its bottom side in order to install the accessories� Be aware that the splashback is
unsupported at this time and can be bent out of shape by trying to support the entire weight of the sink on the edge of the splashback�
There are three sink drains in the Power Soak that must be installed� The drain with a valve built into the body is installed in the bottom of the
tank and oriented with the drain valve handle toward the front of the sink� Each drain flange must be sealed to its mating surface in the sink�
The drains with built-in valves will be oriented with the handle connection toward the front of the sink� From inside the sink, insert the drain
through the drain hole and seat the flange against the sheet metal surface of the tank� Be sure that the sealant compresses to where the rim
of the drain actually touches the sheet metal surface of the sink� If the drain does not touch the sink it will work loose and leak as the sealant
compresses over time�
From the outside of the tank place the rubber vibration ring over the threaded body of the drain followed by the Teflon ring and then the drain
nut� Tighten the nut “hand tight” until the handle is installed�
Drain with built-in valve is
installed in the bottom of
the tank
Drain Body
Approved Sealant
Apply a generous bead of a drain sealant around the lip of the drain body�
Do not bend the edge of the splashback
when laying the sink on its back side.
IMPORTANT
Do not bend the edge of the splashback
when laying the sink on its back side.
IMPORTANT
