13
13-1 i-CON Control system
All control system components integral to the applicator unit are factory fitted.
The Instrument has a 4.3" Colour Touch Screen which has 4 basic menu keys (see page 16)
Separate power cable and head unit leads interconnect the tractor and the Seed Applicator Unit.
The following components need to be installed during fitment (packed in hopper from factory)
i-Con Instrument; TJ117C
Instrument cables; TJ118C and TJ242A
Power Cables; FJ107E
GPS Receiver; TJ255B
Cut out Switch; TJ252
13-2 Wiring diagram
13-3 Electrical Connections
Power requirement is 12 volts with a minimum continuous 30amp supply. Ensure the power supply cable is
connected direct to the vehicle battery to ensure maximum power. Connect the positive wire (fused) to the
positive (+) terminal and negative earth connection to the negative (-) terminal
NOTE
the disc should rotate in a clockwise direction when viewed from above.
WARNING
Failure to connect to the vehicle battery may result in control function problems and
possible damage to the vehicle battery and charging system must be in good condition to achieve the best
results. All cables and controls are fitted with matching plugs and sockets.
WARNING
any modifications to the wiring, fuse holder or control system will invalidate any warranty
claim and may effect the performance of the machine
OPTIONAL
6m Radar Cable TJ234
OPTIONAL
Ground Speed Radar TJ233A
Cut Out Switch
Feed
Motor
Hopper Level
Sensor
(not used)
12v Fan
supply cable (Airforce
7m Fused
Power Cable
Junction
Box
TJ119D
6m Instrument
Cable TJ242A
i-Con
Instrument
Instrument Connector
Cable TJ118C
GPS Receiver
