Distributor of STMicroelectronics: Excellent Integrated System Limited
Datasheet of ST62GP-EMU2 - KIT EMULATOR FOR ST6 MCU SER
Contact us: [email protected] Website: www.integrated-circuit.com
ST62GP-EMU2 Emulator User Manual
2 - Getting Started
11/57
2.2
Adapters for SSOP devices
If you wish to emulate SSOP devices, you must order the following adapters:
•
16-pin SSOP adapter (Ref.: DB381).
•
28-pin SSOP adapter (Ref.: DB388).
Refer to
Product Support
on page 53 for a contact list of qualified
STMicroelectronics representatives near you.
2.3
installing the hardware
To set up your emulator hardware, follow these steps:
2.3.1
Step 1: Connecting the emulator to your PC
1
Shut down and power off the PC that is to be connected to the ST62GP-EMU2.
2
Ensure that both the ST62GP-EMU2 emulator and your application board are
disconnected from their power supplies.
3
Connect the parallel interface cable supplied with the ST62GP-EMU2 emulator
kit to a parallel connector on your PC (LPT1 or LPT2).
4
Connect the parallel interface cable to the parallel port connector on the back
panel of the ST62GP-EMU2 (See
Figure 2
).
2.3.2
Step 2: Putting together your emulator probe
1
Select one of the emulator probes supplied in the package and mount the
footprint adapter for SO devices if necessary (refer to
Figure 3
).
Table 1
Figure 2: ST62GP-EMU2 Back Panel
Power ON/OFF
Power Connector
Parallel Port
Switch
12 / 58
12 / 58
