6
Wire Connections
Parts Needed:
From the HEIGH10 Box:
16 Pin Power/Speaker Harness
10 Pin Multi Camera Harness (Optional)
6 Pin SWI*/IR Harness (Optional)
* Refer to pages 18-20 in the HEIGH10 Installation Guide for harness names and illustrations
From the RP4.2-TY11 Box:
Radio Harness (A109-RAD-HAR)
Vehicle/Interface Harness (RP4.2-TY11-HAR V5)
Referencing FIG A at right:
1. Connect the wires from the HEIGH10 16 Pin Power/Speaker Harness to the
RP4.2-TY11 harnesses as shown.
The majority of the wire connections will
match color-for-color.
Note: The three Analog Navigation Output wires on the
RP4.2-TY11-HAR V5 will
not be used and should be capped-off / insulated.
2. Optional Speed Sense Wire: If adding a front camera or HEIGH10 Navigation
Card, connect the Blue wire labeled SPEED on the HEIGH10 10 Pin Multi
Camera Harness to the Pink wire on the RP4.2 harness. Cap-off/insulate if not
using.
3. Optional Steering Wheel Controls: Plug the 3.5mm mini headphone jack on
the RP4.2 harness into the SWI socket on the HEIGH10 6 Pin SWI/IR Harness.
Insulate the Blue/Yellow and Brown wires on the SWC harness as they will not
be used.
Connect and insulate all connections either by using insulated crimp caps or by
soldering connection points and insulating with electrical tape or heat shrink.
Any unused wire ends should be insulated.
* SWI and SWC are Steering Wheel Control harnesses