STINAR Flush & Fill Cart SFFC-70/2, Руководство пользователя

Страница: 20 / 52

SECTION 1 | GENERAL INFORMATION & OPERATING PROCEDURES
Flush & Fill Cart SFFC-70/2 | 20
1.2.3.3 | Flushing the System (Figure 1.2.3.3)
1. Position the flush and fill cart near the aircraft’s service panel and set
the carts brakes.
2. See figure 1.2.3 for the location of hoses, grounding cable and
power cable.
3. Connect the power cable to 480-volts, 3-phase, 60 Hz power source.
4. Connect the supply hose, return hose and bleed hose to the air vehicle.
WARNING!
ENSURE NO POWER IS APPLIED
TO THE POWER CABLE WHEN
DISCONNECTING FROM THE
SERVICE CART.
WARNING!
ENSURE NO POWER IS APPLIED
TO THE POWER CABLE WHEN
CONNECTING TO THE SERVICE
CART.
5. Position valves V1, V2, V3 and V5 with the handles pointed towards
the side of the cart.
6. Set the heater switch to ON.
7. Allow the coolant temperature in the supply tank to stabilize at
90 degrees Fahrenheit. (Refer to the supply temperature gauge,
figure 1.2.3)
8. Push the Pump ON button.
9. Flush the cooling system per applicable aircraft technical order.
10. When flushing is complete, push the Pump OFF button.
11. Set the Heater switch to OFF.
12. Disconnect the supply hose, the return hose and the bleed hose from
the aircraft.
1.2.3.4 Filling the Aircraft with Coolant (figure 1.2.3.3)
1. Position the flush and fill cart near the aircraft’s service panel and set
the carts brakes.
2. See figure 1.2.3 for the location of hoses, grounding cable and
power cable.