© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • All rights and product modifications reserved.
State: 15.06.2016 · S. 3
Mounting instructions for digger „tollo“
Item-No. 51 1100 402
6. After the setting clean the surface of the foundation, place the pre-mounted
play equipment onto it and screw the base plate onto the foundation anchor
with the included heavy-duty dowel M10.
7. Seal the foundation with the safety cover required for the height of fall indi-
cated (critical drop height ≤ 1000 mm). Set up impact-absorbing playground
surfacing according to EN 1176-1, table 4.
Recommended surface material: sand
8. Do not allow to use the equipment before the installation has been finished.
9. Attention:
If the play equipment has been incompletely installed or partly
dismantled when carrying out maintenance and repair work, this may lead to
particular risks of injury for the user. For this reason, make clearly visible that
the equipment shall not be used in such cases.
10. NOTE:
Play equipment, which contain components made of stainless steel
should not come with „normal“ steel parts in contact. Those steel parts may
rub off and leave small steel particles in combination with moisture brown rust
stains.If such corrosion occur on stainless steel parts, they are fine with an
abrasive (240 grit) to remove.
Please take care when transporting and setting up the fact that the compo-
nents are made of stainless steel with no „normal“ steel parts in contact.
Diagram 3: Top view „tollo“
Extent of the
minimum zone
= safety area
5420
2420
Rev.:
Projekt:
BESTELL-NR:
ZG-NR:
BENENNUNG:
OHNE SCHRIFTLICHE ZUSTIMMUNG DER C KAISER GMBH DARF DIESE TECHNISCHE UNTERLAGE WEDER VERVIELFÄLTIGT
NOCH DRITTEN MITGETEILT ODER ZUGÄNGLICH GEMACHT WERDEN NOCH IN SONSTIGER WEISE MISSBRÄEUCHLICH VERWENDET
WERDEN. ZUWIDERHANDLUNGEN WERDEN URHEBERRECHTLICH VERFOLGT.
FREIG:
GEPR:
GEZ:
DATUM:
NAME:
WERKSTOFF
MAßSTAB:
OBERFLAECHEN NACH
DIN ISO 1302 REIHE 2
ZUL. ABWEICHUNG
DIN 2768 - mH
+0,3
-0,3
WERKSTUECKKANTEN
NACH DIN 6784
Gewerbegebiet Larsheck
56271 Kleinmaischeid
Deutschland
A3
29.02.2016
Abmaße:
Fertigung:
Behnke
x
Gewicht:
Draufsicht
0050A-00-00
tollo neu
