Stilevs Utumax UT-8050, Инструкция по эксплуатации

Страница: 15 / 20

15
within 30 seconds if it is placed horizontally and 8 minutes
IV. CLEANING and MAINTENANCE
Before cleaning, remove the plug from the socket and allow the iron to cool down
sufficiently.
• Wipe off the soleplate with a damp cloth and a non-abrasive (liquid) cleaner.
• If the fiber is adhered to the soleplate, use a damp cloth with vinegar to wipe off
the soleplate.
• Never use strong acid or alkali in order to avoid damaging the soleplate.
• If the scale blocks the steam hole, please remove the scale with toothpick; do not
damage the surface of soleplate.
• Stand the iron on its end and let it cool down sufficiently, and meantime pour any
remaining water out of the box, set the dry/steam selector to position “O”.
Defects and repairs
• Do not attempt to replace a defective mains lead .The appliance has to be returned
to an authorized service centre for repair.
Faults-reasons and solutions
Iron emits an odor or smoke
Iron gives off an odor when turned on for
the first time. Oils used during manufacture
need to be burnt off allow ten minutes for
odor to disappear.
Iron does not heat
The iron should be plugged into a 230 Volt
, AC electrical outlet only. The temperature
dial must be set at the desired temperature.
Iron does not steam
The water tank many be empty. Turn the
steam valve to off position and add water
.Allow the iron to heat, and then set the
steam dial to the steam setting.
Burst of steam feature does
not work
The water tank must be at least 1/4
full .Temperature must be set to steam
position. Iron should be in the horizontal
position. Prime pump briefly. Allow a short
pause between shots. Be sure to fully
depress the burst of steam button.
Spry mist feature does not
work
The water tank must be at least 1/4 full. Fill
the iron as described in the section “how
to fill the water tank”.
Iron is leaking
The variable steam dial must be set on”
“,until the iron is hot . The temperature
setting is too low to produce steam. Shot
of steam used too much, allow iron to re-
heat.