Stilevs Utumax UT-088, Инструкция по эксплуатации

Страница: 14 / 20

14
as the water tank is filled with water.
• Press the spray button for this function
NOTE : This button has to be pressed repetitively to start this function for the
first time.
Shot of steam:
Shot of steam give extra steam for removing persistent wrinkles.
• Place the temperature selector at the “max”position and wait until the pilot
light goes out
• Wait for a few seconds for the steam to penetrate the fibre before pressing
again.
NOTE : For the best steam quality, do not use more than three successive bursts
each time. Several pumping actions are needed to start this function. Excessive
use of this feature will cause the iron to cool , ensure that the pilot light is out,
before operating the shot of steam control
Vertical Steam:
“Burst of Steam” can also be applied when holding the iron in vertical position,
this is useful for removing creases from hanging clothers, curtains, etc...
Dry Ironing:
• Set the Dry/Steam Selector to position O(=No Steam)
• As per washing label of various clothes, set the correct ironing temperature to
begin a ironing.
Anti Calc:
• With a small filter built-in,which can make hard water soft, thus preventing
any calc or flake accumulated on the surface of soleplate,this features can
prolong the life of the iron for long use.
Anti Drip:
• With a bimetal assembled inside the iron, which can close the steam when the
iron soleplate becomes very low, so water leakage will never happen with this
features.
Self-Cleaning:
Use the self-cleaning function once every two weeks.If the water in your area
is very hard(i.e, when flakes come out of the soleplate during ironing),the self-
cleaning function should be used more frequently.). Make sure the appliance is
unplugged,set the Dry/Steam Selector to steam level “O”, fill the water tank to the
MAX position, do not put vinegar or other dealing agents in the water tank.,select
the maximum ironing temperature,put the plug in the wall socket,unplug the iron
when the power indicator lighter has gone off, hold the iron over the sink, press
the self-cleaning button until the steam cover jump out and then use hand to
pull the steam cover upward a little,no need to pull the steam cover completely