Stihl WP 230, Инструкция по эксплуатации, Страница: 15 / 27

0458-494-0121-A
13
English 8 Starting and Stopping the Engine
► Turn the tank cap counterclockwise until it can be
removed.
► Remove the fuel tank cap.
NOTICE
Bright light, sunlight and extreme temperatures can cause
the fuel mix to separate much faster. The water pump can be
damaged if it is used with a fuel mix that has become
separated.
► Thoroughly mix the fuel.
► Do not use fuel mix that has been stored for more than 30
days.
► Fill the tank to within no more than 15 mm of the brim,
taking care not to spill any fuel.
► Fit the tank cap on the tank opening.
► Turn the tank cap clockwise and tighten it down firmly by
hand.
The fuel tank is closed.
8.1 Selecting the Correct Starting Procedure
When must the engine be prepared for starting?
The engine must be prepared for starting if one of the
following conditions apply:
– The engine is at ambient temperature.
– The engine stopped when accelerated for the first time.
– The engine stopped because the fuel tank was empty.
► Prepare engine for start and then start the engine.
When can the engine be started without preparation?
The engine can be started without preparation if it has been
running for at least 1 minute and only shut down for a short
work break.
► Start the engine.
8.2 Preparing Engine for Start
► Select the correct starting procedure.
► Stand the water pump on a level surface.
0000-GXX-4727-A0
0000-GXX-4728-A0
8 Starting and Stopping the Engine
A video is available for this chapter
www.stihl.com/sxxiaD