Stihl SR 430, Руководство пользователя

Страница: 47 / 111

46 SR 430, SR 450
The rewind spring is correctly
tensioned when the starter grip sits
firmly in the rope guide
bushing (arrow) without drooping to
one side. If this is not the case,
tension the spring by one additional
turn.
When the starter rope is fully
extended, it must still be possible to
rotate the rope rotor at least another
half turn before maximum spring
tension is reached. If this is not the
case, reduce spring tension since
there is otherwise a risk of
breakage.
To reduce spring tension:
Pull the rope out, hold the rope rotor
steady and take off one turn of the
rope.
– Fit the starter cover, b 6.2
0002RA126 TG
6.7 Replacing the Rewind
Spring
– Troubleshooting, b 3.1
The replacement spring comes
ready for installation in a spring
housing.
– Remove the starter cover, b 6.2
– Relieve tension of rewind spring if
necessary and remove the rope
rotor,
b 6.4
– Remove any remaining pieces of
old spring.
– Lubricate the spring with a few
drops of STIHL special lubricant
before installing,
b 13
: Line up the replacement spring
and spring housing – the anchor
loop (2) must be above the
lug (1).
0002RA127 TG
2
1
– Fit the rewind spring with housing
in position.
Take care to ensure the rewind
spring is not pushed out of the
spring housing by the starter post
– The rewind spring may pop out
and unwind.
: Push the rewind spring with
spring housing into its seat in the
starter cover.
Make sure that the spring
housing (1) is properly seated.
If the rewind spring has popped out,
refit it in the starter cover as follows:
– Arrange the spring in its original
position.
0002RA128 TG
1