11
Top:
Ellbow fitted to fan housing
Center: Spraying attachment fitted
Bottom: Stop cock lever in vertical position
Assembly of Unit
The unit is partly disassembled for ease of shipment and
must be completely assembled before it is used for the
first time.
The tools on the underside of the unit (1 combination
wrench and 1 carburetor screwdriver) should be used for
the assembly work.
Mounting the elbow
- Line up the stops on the elbow (1) and fan housing
stub (2).
- Push the elbow (1) into the stub (2) as far as it will go.
- Fit a nut (3) into each of the molded hexagon seats on
the stub.
- Insert a screw (4) into each nut from the other side and
tighten moderately (it must still be possible to turn the
elbow).
Important:
The throttle cable with integrated stop switch
wire is already connected to the control handle and the
engine and must not be kinked during assembly.
- Attach throttle cable with the retainer (5) to the pleated
hose.
Mounting the spraying attachment
Insert extension tube (12) into the pleated hose (7) as far
as it will go.
- Rotate the pleated hose (7) to the left
(counterclockwise) as far as the stop and leave it in
that position until you have completed the following
adjustments.
