Stihl RE 95, Инструкция по эксплуатации

Страница: 57 / 176

0458-815-9621-A
55
English 9 Connecting the pressure washer to the power supply
► Unscrew connector (1).
► Screw water filter (2) onto connector (3) and tighten hand-
tight.
Connecting the water hose
► Fill water hose (1) with water until there is no air left in the
water hose.
► Screw coupling (2) onto connector (3) of water filter and
tighten hand-tight.
► Suspend the suction cup (4) in the water source so that
the suction cup (4) does not touch the bottom.
► If the spray gun is attached to the high-pressure hose:
remove the spray gun.
► Hold the high-pressure hose downward.
► Switch on pressure washer and run it until an even jet of
water is delivered by the high-pressure hose.
► Switch off pressure washer.
► Attach spray gun to the high-pressure hose.
► Squeeze and hold down spray gun trigger.
► Switch on pressure washer.
9.1 Connecting the pressure washer to the power
supply
► Move the rocker switch (1) to the 0 position.
► Remove connecting cord (2) from the holders (3).
► Plug the connecting cord (2) into a correctly installed
socket.
10.1 Switching on the pressure washer.
When the pressure washer is switched on, voltage
fluctuations may occur under unfavorable mains conditions
with a power line impedance greater than 0.15 Ohm. The
voltage fluctuations may negatively affect other connected
electrical appliances.
3
2
1
0000-GXX-6402-A0
3
2
1
0000-GXX-6403-A0
1
4
9 Connecting the pressure washer to the
power supply
10 Switching the pressure washer on and
off
2
1
3
3
0000-GXX-6404-A0