Stihl Operating instructions, Инструкция по эксплуатации

Страница: 35 / 104

FS 460 C-M, FS 460 C-M L
English
33
N Lift the front of the cap (2) and push
it to the rear to disengage.
N Leave the cap to one side.
N Pull off the spark plug boot (3).
N
Unscrew the spark plug.
Wrong fuel mix (too much engine oil in
the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition
of the spark plug. These factors cause
deposits to form on the insulator nose
which may result in trouble in operation.
If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
N Remove spark plug – see "Starting /
Stopping the Engine".
N Clean dirty spark plug.
N Check electrode gap (A) and
readjust if necessary – see
"Specifications".
N Use only resistor type spark plugs of
the approved range.
Rectify problems which have caused
fouling of spark plug:
N Too much oil in fuel mix.
N Dirty air filter.
N Unfavorable running conditions,
e.g. operating at part load.
Fit a new spark plug after approx. 100
operating hours
or earlier if the
electrodes are badly eroded.
Installing the Spark Plug
N Screw the spark plug into the
cylinder.
N
Press the spark plug boot firmly
onto the spark plug.
3
9926BA021 KN
000BA002 KN
Warning!
To reduce the risk of fire and burn injury,
use only spark plugs authorized by
STIHL. Always press spark plug boot (2)
snugly onto spark plug terminal (1) of
the proper size. (Note: If terminal has
detachable SAE adapter nut, it must be
attached.) A loose connection between
spark plug boot and ignition wire con-
nector in the boot may create arcing that
could ignite combustible fumes and
cause a fire.
0
00BA036 TR
1