Stihl MS 500i, Инструкция по эксплуатации

Страница: 15 / 32

9 Starting and Stopping the
Engine
9.1 Starting the Engine
0000-GXX-6458-A0
3
2
1
► Engage the chain brake (2).
► Pull off the chain guard (scabbard).
► Depress the decompression valve (1).
► Press the manual fuel pump bulb (3) at least
eight times.
0000-GXX-2936-A0
► Hold the chainsaw firmly in one of three ways:
–
Place the saw on level ground. Hold the
saw firmly on the ground with your left hand
on the handlebar – your thumb should be
under the handle. Put the toe of your right
boot into the rear handle and press down.
–
Place the saw on level ground. Hold the
saw firmly on the ground with your left hand
on the handlebar – your thumb should be
under the handle. Put the heel of your right
boot into the rear handle and press down.
–
Hold the saw firmly with your left hand on
the handlebar – your thumb should be under
the handle. Hold the rear handle tightly
between your legs, just above the knees.
0000-GXX-2937-A0
► Pull the starter grip slowly with your right hand
until you feel it engage.
► Pull the starter grip quickly and allow the
starter rope to rewind several times until the
engine runs.
The engine runs at idling speed.
NOTICE
■ Do not accelerate the engine with the chain
brake engaged since this can damage the
chain brake.
► Disengage the chain brake before you start
cutting.
► Disengage the chain brake.
Your saw is ready for operation.
9.2 Stopping the Engine
2
0000-GXX-9935-A0
1
► Release the throttle trigger (2).
The engine runs at idling speed.
► Depress the stop switch (1).
The engine stops and the stop switch (1)
springs back to the off position.
► If the engine does not stop: Do not use the
chainsaw and contact your STIHL servicing
dealer for assistance.
The saw has a malfunction.
10 Checking the Saw
10.1 Checking the Chain Sprocket
► Shut off the engine.
► Disengage the chain brake.
► Remove the chain sprocket cover.
► Remove the bar and chain.
0000-GXX-3162-A0
a
9 Starting and Stopping the Engine English
0458-809-0121-B. VA0.A21. 15