Stihl MS 391, Руководство по безопасности

Страница: 44 / 68

MS 311, MS 391
English
22
Positions of the Master Control lever
Stop 0 – engine off – ignition is switched
off
Operating position
F
– engine is
running or can start
Warm start
n
– this position is for
starting the warm engine – the Master
Control lever returns to the operating
position when the throttle trigger is
squeezed
Cold start
l
– this position is for
starting the cold engine
Adjust Master Control lever
To adjust the Master Control lever from
the operating position
F
to cold start
l
,
press and hold down the throttle trigger
lockout and throttle trigger
simultaneously – set Master Control
lever.
To set the Master Control lever to warm
start
n
, first set it to cold start
l
, then
push the Master Control lever into the
warm start
n
position.
Switching to the warm start
n
position
is only possible from the cold start
l
position.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the Master Control lever
to jump from the warm start
n
position
to the operating position
F
.
To switch off the engine, set the Master
Control lever to Stop
0 .
Position choke shutter closed
l
– if engine is cold
– if the engine stalls during opening of
throttle after starting
– if the fuel tank has run empty
(engine stalled out)
Position starting acceleration
n
– if engine is warm (once the engine
has been running for approx. one
minute)
– when the engine has turned over for
the first time
– after ventilation of the combustion
chamber, if the engine was flooded
Holding the chain saw
There are two ways to hold the chain
saw during starting.
On the ground
N
Place the chain saw securely on the
ground – assume a steady stance –
the saw chain must not touch any
objects and also must not touch the
ground
N
With the left hand on handlebar,
press the chain saw firmly against
the ground – thumb wrapped
around the handlebar
N
Place your right foot through the
rear handle
Starting / Stopping the
Engine
STOP
0
001BA140 KN
0001BA017 KN