Stihl MS 270, Инструкция по эксплуатации

Страница: 26 / 52

MS 270, MS 270 C, MS 280, MS 280 C
English
24
Adjust Master Control lever
To adjust the Master Control lever from
the operating position
F to cold start l ,
press and hold down the throttle trigger
lockout and throttle trigger
simultaneously – set Master Control
lever.
To set the Master Control lever to warm
start
n , first set it to cold start l , then
push the Master Control lever into the
warm start
n
position.
Switching to the warm start n position
is only possible from the cold start l
position.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the Master Control lever
to jump from the warm start
n
position
to the operating position F .
To switch off the engine, set the Master
Control lever to Stop
0 .
Position choke shutter closed l
– if engine is cold
– if the engine stalls during opening of
throttle after starting
– if the fuel tank has run empty
(engine stalled out)
Position starting acceleration n
– if engine is warm (once the engine
has been running for approx. one
minute)
– When the engine has turned over
for the first time
– after ventilation of the combustion
chamber, if the engine was flooded
Holding the chain saw
There are two ways to hold the chain
saw during starting.
On the ground
N Place the chain saw securely on the
ground – assume a steady stance –
the saw chain must not touch any
objects and also must not touch the
ground
N With the left hand on handlebar,
press the chain saw firmly against
the ground – thumb wrapped
around the handlebar
N Place your right foot through the
rear handle
Between the knees or thighs
N clamp the rear handle between the
knees or thighs
N grip the handlebar firmly with the left
hand – thumb wrapped around the
handlebar
146BA003 KN
146BA004 KN