Stihl KombiTool HT-KM 4182, Инструкция по эксплуатации

Страница: 17 / 32

HT-KM
English
15
The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate without chain lubrication.
If the chain runs dry, the whole cutting
attachment will be irretrievably damaged
within a very short time. Always check
chain lubrication and the oil level in the
tank before starting work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
Not all basic power tools are equipped
with a shoulder strap and carrying ring.
N
Fit the carrying ring – see "Mounting
the Attachment".
The shoulder strap is available as a
special accessory.
The type of carrying ring, shoulder strap
and carabiner depends on the market
and the basic power tool.
Shoulder Strap
N
Put on the shoulder strap (1).
N
Adjust the length of the strap – with
the machine attached, the
carabiner (2) must be about a
hand's width below your right hip.
Attaching Machine to Shoulder Strap
N
Attach the carabiner (1) to the
carrying ring (2) on the shaft.
Disconnecting Machine from Shoulder
Strap
N
Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Throwing Off the Machine
WARNING
The machine must be quickly thrown off
in the event of imminent danger. To
throw off the machine, use the
procedure described under
"Disconnecting Machine from Shoulder
Strap". Practice removing and putting
down the machine as you would in an
Checking Chain Lubrication
390BA048 KN
Fitting the Harness
1
0000-GXX-0503-A0
2
1
2
1
2
0000-GXX 1056-A0
2
1
2
0000-GXX 1058-A0
1