KM 90 R
English
15
N
Press the manual fuel pump
bulb (9) at least five times – even if
the bulb is filled with fuel.
Cranking
N
Place the power tool on the ground
so that it rests on the machine
support: Check that the working tool
is not touching the ground or any
other obstacles – see also "Starting
/ Stopping the Engine" in the
KombiTool instruction manual.
N
Make sure you have a firm footing,
either standing, stooping or
kneeling.
N
Hold the unit firmly on the ground
with your left hand and press down
– thumb under the fan housing – do
not touch the throttle trigger or
trigger lockout.
NOTICE
Do not stand or kneel on the drive tube.
N
Hold the starter grip with your right
hand.
N
Pull the starter grip slowly until you
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N
Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N
Continue cranking.
N
After no more than five pulls, move
the choke knob to
e
.
When engine begins to fire
N
Continue cranking.
As soon as the engine runs
N
Blip the throttle trigger immediately.
The slide control moves to the
normal run position
F
– and the
engine settles down to idle speed.
WARNING
Make sure the carburetor is correctly
adjusted. The working tool must not
move when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
N
Push the slide control in the
direction of the arrow on the stop
symbol (
h
) to STOP-0.
At very low outside temperatures
As soon as the engine runs:
N
Blip the throttle trigger to disengage
the starting throttle position. The
slide control moves to the normal
run position
F
– and the engine
settles down to idle speed.
N
Open the throttle slightly.
N
Warm up the engine for a short
period.
g
If the engine is cold
e
for warm start – also use this posi
-
tion if the engine has been running
but is still cold.
552BA014 KN
552BA015 KN
552BA016 KN
