16
English / USA
KB, KW
Mounting the Loop Handle
:
Place the clamp (
5
) in the loop
handle (
1
) and fit handle in position
on the drive tube (
6
).
:
Fit the clamp (
7
).
:
Line up the holes.
:
Fit washers (
8
) on the screws (
9
)
and insert screws through the holes.
:
Screw on the square nuts (
10
) as far
as stop.
Aligning the Loop Handle
:
Adjust the loop handle (
1
) to the
most comfortable position for the
user and application.
Distance
A
must not be more than
22“ (55 cm).
About 14“ (35 cm) is recommended.
:
Tighten down screws on loop
handle firmly.
:
For position of carrying eye (clamp)*
see "Mounting the Loop Handle".
:
Position the clamp
(1)
so that the
tapped hole is on the left-hand side
of the drive tube (viewed from
powerhead).
:
Squeeze the ends of the clamp
together and hold it that position.
:
Insert M 6 x 14 screw
(2)
.
:
Line up the carrying eye.
:
Tighten down the screw.
*
see “Guide to Using this Manual”
1
6
002BA157 KN
10
7
10
5
9
8
9
8
002BA183 KN
1
A
Fitting Carrying Eye*
(Clamp)
002BA142 KN
1
2
1
