Stihl GHE 135 L, Инструкция по эксплуатации, Страница: 17 / 328

EN
ES
15
PT
SL
SK
HU
SR
HR
CS
LV
LT
RO
RU
BG
UK
0478 201 9812 A - EN
GHE 135.0 L, GHE 140 L:
– Remove the shredder bag. ( Ö 10.6)
● Lever wheel cap (1) from wheel (I)
using a screwdriver.
● Insert bolt (J) with washer (L) from the
inside through the bore in wheel
carrier (B). Push washer (L) and
sleeve (K) onto bolt (J). Push wheel (I)
onto sleeve (K). Fit nut (M) with
washer (L) and tighten to 5-7 Nm.
● Centre wheel cap (1) on wheel (I) and
press in until wheel cap (1) engages.
– Repeat this procedure on the other
side.
Installing the feet:
● Insert the bolt of foot (F) through the
bore in wheel carrier (B) from below. Fit
washer (G) on the bolt, screw on cap
nut (H) and tighten to 4-6 Nm.
– Repeat this procedure on the other
side.
7.2 Assembling the machine
GHE 135 L
● Remove the shredder bag.
(
Ö 10.6)
● Position upper machine (A) on wheel
carrier (B) and centre carefully. Ensure
that rubber cover (1) is positioned
correctly – rubber cover (1) must not be
clamped between the upper machine
and the black cover on the wheel
carrier. Install upper machine (A) on
wheel carrier (B) by screwing in four
screws (D). Tighten screws (D) to 1-
1,5 Nm.
● Insert the shredder bag. ( Ö 10.5)
7.3 Storing the Allen key
● Push Allen key (O) into holder (1)
on the machine.
8.1 What material can be processed?
Tree and hedge cuttings, thujas, spruce
branches, branches with side shoots and
twigs with leaves, greens, berry bushes,
bundled flower material which is not too
damp.
8.2 What material cannot be
processed?
Stones, glass, bits of metal
(wire, nails, etc.) or plastic
must not be fed into the
garden shredder.
As a general rule:
Any materials that do not belong on the
compost heap should not be processed
using the garden shredder.
8.3 Maximum branch diameter
The data relates to freshly cut branch
material:
Maximum branch diameter
GHE 135 L: 35 mm
GHE 140 L: 40 mm
8.4 Feeding the garden shredder
Even branches with side shoots and
twigs can be processed thanks to
the STIHL cloverleaf opening.
● Guide tree and hedge cuttings as well
as branch material slowly through feed
opening (13) to the blade roller.
Branches are drawn into the shredder
without kickback.
● Run the machine until empty after each
work operation.
8.5 Correct motor load
Always feed the garden shredder
continuously and steadily.
4
8. Notes on working with the
machine
Tree and hedge cuttings should be
processed when fresh, as the
shredding performance is better
with fresh than with dried-out or wet
material.
5
Cut up thick branches and
branches with side shoots
beforehand using loppers.
In order to prevent the garden
shredder becoming blocked, tough
shredding material containing earth
should be combined with dry
branches.
Only feed the garden shredder at
maximum motor speed.
Risk of injury!
Hold branches being drawn in by
the shredder lightly and guide them
to just before the feed opening. Do
not grip branches firmly or pull them
back out of the shredder.
1