Stihl FT 250, Инструкция по эксплуатации, Страница: 14 / 40

FT 250
English
12
Mounting the control handle
N
Take out the screw (1) – the nut (2)
remains in the control handle (3).
N
Push the control handle onto the
handlebar (5) until the holes (6) line
up – the throttle trigger (4) must
point towards the gearbox.
N
Insert the screw (1) and tighten it
down firmly.
Fitting the throttle cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
N
Push the throttle cable (1) into the
retainer (2).
Adjusting the throttle cable
N
Check adjustment of throttle cable –
see chapter on "Adjusting the
Throttle Cable".
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
Adjust the throttle cable only after the
unit is fully assembled – the control
handle must be in the normal operating
position.
N
Use a suitable tool to push the slide
to the end of the slot (see
illustration).
N
Press down the throttle trigger
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
1
3
4
5
6
002BA241 KN
6
2
2 2
1
262BA052 KN
1
2
Adjusting the Throttle Cable
002BA163 KN
STOP
249BA017 KN
1
2