FSA 90 R
English
14
Blocking the Shaft
The output shaft (2) must be blocked
with the stop pin (6) to mount or remove
cutting attachments. The stop pin is
included with the machine and is
available as a special accessory.
N
Push the stop pin (6) into the
hole (7) in the motor housing.
N
Rotate the shaft, nut or cutting
attachment to line up the hole in the
fanwheel (1) with the stop pin (6).
N
Push the stop pin (6) home until its
end is level with the blades on the
fanwheel (1).
The shaft is now blocked.
Mounting the Cutting Attachment
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
N
Screw the mowing head
counterclockwise on to the shaft (2)
as far as stop.
N
Blocking the shaft
N
Tighten down the mowing head
firmly.
NOTICE
Remove the tool used to block the shaft.
Remove the mowing head.
N
Block the shaft.
N
Unscrew the mowing head
clockwise.
Mounting the Metal Cutting Attachment
Keep the leaflet and packaging of the
metal cutting attachment in a safe place.
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Mount only one metal cutting
attachment.
Check direction of rotation of cutting
attachment
The cutting edges of the grass cutting
blades (1) and (2) may point in either
direction – these cutting attachments
must be turned over regularly to reduce
one-sided wear.
Cutting edges of grass cutting blade (3)
must point clockwise.
WARNING
Direction of rotation is indicated by an
arrow on the inside of the deflector.
7
6
2
3988BA014 KN
6
2
3988BA015 KN
1
3
2
681BA050 KN
