FS 90, FS 90 R
English
20
N
Pull out the wing screw – the
washer (6) remains on the wing
screw.
N
Separate the clamp moldings – the
springs (4 and 5) remain in the
lower clamp.
Securing the handlebar
N
Place the handlebar (7) in the lower
clamp (1) so that distance A is no
more than 15 cm (6 in).
N
Place the upper clamp in position
and hold both clamp moldings
together.
N
Push the wing screw through the
two clamps as far as stop – hold all
parts together and secure them.
N
Place the secured assembly on the
handle support (8) with the wing
screw at the side nearest the
engine.
N
Push the wing screw into the handle
support as far as stop and then
screw it down – but do not finally
tighten yet.
N
Line up the handlebar at a right
angle to the drive tube – check
distance A again.
N
Tighten down the wing screw firmly.
Mounting the control handle
N
Take out the screw (9) – the nut (10)
remains in the control handle (11).
N
Push the control handle onto the
handlebar (7) until the holes (13)
line up – the throttle trigger (12)
must point towards the gearbox.
N
Insert the screw (9) and tighten it
down firmly.
Fitting the throttle cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
1
7
A
250BA046 KN
002BA234 KN
8
Содержание FS 90
Страница 2: ...Instruction Manual 1 53 Manual de instrucciones 54 111...
Страница 114: ...FS 90 FS 90 R espa ol EE UU 112...
Страница 115: ......