Stihl FS 460 C-M, Инструкция по эксплуатации

Страница: 34 / 116

FS 460 C-M, FS 460 C-M L, FS 490 C-M, FS 490 C-M L
English
32
N
Hold the machine firmly with your
right hand on the drive tube, handle
support or handlebar.
N
With the machine behind you, press
it against the left side of your body.
N
Hold the starter grip with your left
hand.
N
Pull the starter grip steadily.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N
Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N
Continue cranking until engine runs.
As soon as the engine runs
N
Make sure the engine runs
smoothly.
If the engine stalls:
N
continue cranking until the engine
runs.
As soon as the engine runs smoothly
N
After a cold start, allow the engine to
warm up in the Start
}
position.
Machine is ready for use.
If you have started the machine for the
first time, refer to the notes on "Starting
for first time" in section "Other Hints on
Starting".
N
Depress throttle trigger lockout and
pull the throttle trigger – the choke
knob moves to the Run
F
position.
WARNING
The cutting attachment must not rotate
in the Run
F
position with the engine at
idling speed.
If the cutting attachment rotates when
the engine is idling, refer to notes in
chapter on "Adjusting the Thottle Cable"
or have the machine serviced by your
dealer. STIHL recommends a STIHL
servicing dealer.
N
Attaching Machine to Harness
N
Machine is ready for use.
Stopping the engine
N
Depress the momentary contact
stop switch – the engine stops –
release the stop switch – it springs
back to the run position.
Other Hints on Starting
Starting for first time
N
Depress the throttle trigger – do not
press down the throttle trigger
lockout.
If engine speed increases or the cutting
attachment rotates:
N
Go to section "Stopping the
Engine".
N
Go to "Adjusting the Throttle Cable".
If the engine speed does not increase,
your machine is ready for operation.
6BA013 KN
6BA014 KN
002BA485 KN
6BA024 KN