36
English
FR 350, FR 450, FR 480
:
Ease the cap (
5
) out of the starter
grip.
:
Remove remaining rope from the
rotor and grip.
:
Tie a simple overhand knot in the
new rope – see "Specifications" –
and then thread it through the top of
the grip and the rope bush (
6
).
:
Refit the cap in the grip.
:
Thread the rope through the rotor
and secure it with a simple
overhand knot.
:
Coat rope rotor bearing bore with
non-resinous oil.
:
Slip rotor over starter post – turn it
back and forth to engage anchor
loop of rewind spring.
:
Refit the pawl (
4
).
:
Fit the washer (
3
).
:
Install spring clip (
2
) on starter post
and engage it on the pawl's peg –
the spring clip must point clockwise.
Tensioning rewind spring
:
Make a loop in the unwound
starter rope and use it to turn
the rope rotor six full revolutions
counterclockwise.
:
Hold the rotor steady – pull out and
straighten the twisted rope.
:
Release the rope rotor.
:
Let go of rope slowly so that it winds
onto the rotor.
The starter grip must locate firmly in
the rope guide bush. If the grip
droops to one side: Add one more
turn on rope rotor to increase spring
tension.
When the starter rope is
fully extended
it must still be possible to rotate the rotor
another half turn (FR 350) or another
one and a half turns (FR 450, FR 480).
If this is not the case, the spring is
overtensioned and
could break
.
6
5
271BA034 KN
256BA034 KN
3
2
4
256BA032 KN
7
271BA037 KN
