► Position the control handle (7) on the handle‐
bar (3), trigger facing the gear housing, and
line up the hole in the control handle with the
hole in the handlebar.
► Fit the nut (7).
► Screw in and securely tighten the screw (6).
It is not necessary to remove the bike handle
again.
7.2
Mounting the gear housing
4
1
2
3
0000-GXX-A337-A0
► Loosen the screw (4).
► Push the shaft (1) into the gear housing (3)
and turn it until the gear shaft (2) engages.
► Tighten the screw (4) slightly.
► Position the gear housing (3) so that it faces
upward.
► Tighten the screw (4) securely.
The gear housing does not need to be removed
again.
8
Adjusting Weeder for User
8.1
Fitting and Adjusting the Full
Harness
1
2
0000097399_001
► Putting on the Full harness (1).
► Adjust the full harness (1) so that the carabi‐
ner (2) is about a hand’s width below your
right hip.
8.2
Adjusting the Bike Handle
The bike handle can be set to different positions
to suit the height and reach of the user.
► Switch off the weeder and remove the battery.
► Use the perforated strip to hook the weeder
into the carabiner of the carrying system.
1
2
0000097032-001
► Loosen the wing screw (1).
► Swing the bike handle (2) to the required posi‐
tion.
► Tighten the wing screw (1) securely.
8.3
Balancing the weeder
► Switch off the weeder.
1
2
0000097031-001
► Hook the perforated strip (2) into the carabi‐
ner (1).
0000-GXX-3034-A0
► The weeder should be balanced so that the
rider plate just rests on the ground.
► If the weeder cannot be balanced: Hook the
carabiner (1) into another hole in the perfora‐
ted strip (2) and check the balance again.
English
8 Adjusting Weeder for User
10
0458-845-0101-A
