Stihl DYNAMIC Protect MS, Инструкция по эксплуатации

Страница: 6 / 84

6
G
STIHL Protective Gloves for Chain Saw Users
To guarantee the best possible protection and comfort when using this
safety product it is essential that you read and observe the following
information:
1. Warning!
No safety equipment can provide 100% protection against injury from
a power tool (e.g. chain saw).
The degree of protection depends on many different factors (e.g.
engine speed and torque, intensity and duration of contact with the
tool, etc.).
In compliance with the manufacturer's instructions, chain saw must
always be held firmly with both hands during operation.
These protective gloves are no substitute for safe working
techniques. Improper use of the power tool can cause accidents. For
this reason it is essential to observe the safety regulations issued by
the relevant authorities (employers' liability insurance associations,
etc.) and the safety warnings and instructions in the instruction
manual of the power tool being used.
Before each use, check the condition of the gloves (e.g. optical
condition of product). Discard the gloves immediately if they are
damaged or have been modified.
2. STIHL protective gloves require special treatment and care to
maintain their protective function.
Cleaning:
If heavily soiled, wash by hand in soapy water and then rinse
thoroughly. Dry at room temperature, not near a source of heat. Treat
regularly with a leather conditioner (water-repellent, keeps leather
moisturized).
Improper cleaning and care may have a negative influence on the
product’s protective function. Please follow the cleaning and care
instructions.
Any modification of the product may have a negative influence on its
protective function. For this reason do not attempt to modify the
product in any way. Immediately discard products that have been
modified.
This protective product has been designed for the users of handheld
chain saws. It does not provide protection against other risks (e.g.
other areas of operation such as construction work, contact with
electric energy / current, when operating cut-off machines, pressure
washers, etc.).
FT_712_0000_0_09_170208_99.book Seite 6 Donnerstag, 9. Februar 2017 1:42 13