Stihl BR 550, Руководство по обслуживанию

Страница: 13 / 62

12 BR 500, BR 550, BR 600
– Troubleshooting, b 4.1
Relieving tension of rewind
spring
The rewind spring will not be under
tension if the starter rope is broken.
– Pull out the starter rope about
5 cm and hold the rope rotor
steady.
– While still holding the rotor
steady, take three turns of the
rope off the rotor.
– Pull out the starter rope and then
slowly let go of the rotor.
– Remove the pawls, b 5.3
: Remove the washer (1).
: Carefully remove the rope rotor
(2) from the starter post
– Remove worn or broken starter
rope, b 5.5
452RA002
1
VA
2
Install in the reverse sequence.
– Coat the bore in the rope rotor
with STIHL special lubricant,
b 13.
: Fit the rope rotor on the starter
post so that the driver (1) on the
rotor slips behind in the inner
spring loop (2).
452RA003
VA
2
1
Install all other parts in the reverse
sequence.
: Fit the washer and the pawls and
engage the spring clip (1) in the
groove on the starter post (2).
: Make sure the spring clip (1)
engages the guide pegs (arrows)
on the pawls and points them
counterclockwise
452RA001
1
VA
2
Handle the spring clip with care.
The rewind starter may not function
properly if the spring clip is
deformed.
– Tension the rewind spring, b 5.8
Install all other parts in the reverse
sequence.
5.4 Rope Rotor
RA_452_00_01_02.book Seite 12 Donnerstag, 16. Februar 2012 11:52 11