Stihl BF-MM, Инструкция по эксплуатации

Страница: 14 / 22

13 BF-MM, BK-MM
English
Mounting the MultiTool
: Arrange the blades in the order they
will be fitted on the shaft, noting the
following points:
Left-hand and right-hand blades are
different. The direction of rotation is
marked with arrows on the gearbox
and blades. Make sure the arrows
point in the same direction.
: Rotate the inner right-hand blade ( 4 )
on the shaft until it can be pushed
into position – check the direction of
rotation again (arrows).
The hub of the inner blade is larger
than that of the outer blade.
: Rotate the outer right-hand blade
(
5 ) on the shaft until it can be
pushed into position – check the
direction of rotation again (arrows).
: Insert and engage hitch pin ( 6 ) in
the hole in the shaft – fold the hitch
pin flat against the blade.
: Use the same procedure to mount
the blades on the left-hand side.
Starting
: Secure the handlebar in the normal
operating position.
: Retract the wheels, if fitted
: Retract the spur, if fitted
: Place the unit on a patch of clear
ground. It must rest securely on the
engine flange and the support on
the frame. Check that the blades are
not touching the ground or any other
obstacles.
: Make sure you have good balance
and secure footing – as shown in
the illustration. To reduce the risk of
injury from contact with the rotating
blades, always stand to the side of
the power tool, never in front of or
near the blades.
: With your left hand on the loop
handle, press the unit firmly against
the ground.
469BA029 KN
4 5
6
Starting / Stopping
the Engine
469BA023 KN