Stihl 4141 Series, Руководство пользователя

Страница: 33 / 43

32 Series 4141 Powerhead
The interlock lever must be
behind the throttle trigger.
– Tighten handle screws to 2.5 Nm
(1.8 lbf.ft).
392RA090
VA
– Remove the filter cover - see 9.1.
Disconnect wires (1 and 2) on
throttle cable.
VA
380RA078
2
1
Loosen hex nut (2) and unscrew
tensioning sleeve (1) from the
retainer.
– Take out the throttle cable
through the slot.
Detach throttle cable nipple (3)
VA
380RA079
1 2 5 4
3
from slotted pin (4) on lever (5).
Remove the throttle trigger - see
8.1.
Reassemble in the reverse
sequence.
Adjust the throttle cable - see 8.3.
Note:
Throttle lever (1) must butt against
the stop (3) when throttle trigger is
squeezed (full throttle). Throttle
lever must butt against the low
speed screw (2) (stop screw) when
the trigger is in the idle position.
4
VA
380RA080
3 1 2
The throttle cable is adjusted by
moving the tensioning sleeve (4).
– Adjust idle speed correctly - see
9.5.
Throttle lever must butt against
the low speed screw. Now shut
off the engine.
– Remove the filter cover - see 9.1.
– To adjust the throttle cable, open
throttle wide on control handle.
Use tensioning sleeve (1) to
adjust the throttle cable until
lever (3) butts against stop (2).
1
VA
380RA104
2 3
8.2 Replacing the
Throttle Cable 8.3 Adjusting the
Throttle Cable