CAUTION:
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-
CLIPS (#22) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED
INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE
WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.
5
8.
Rotate U-support (#21) that is on bottom of Table Top
until you see the screw holes in the slots of U-clips (#22).
If necessary Slide U-support (#21) side to side and back
and forth to see holes. See
Figure 5
&
Detail B
.
9.
Insert Screw (#35) through slot in U-clip (#22) and into U-support
(#21). See
Figure 5
&
Detail B
. Thread screw all the way into U-
support until it touches the back of the tube. There should be about
3/8” of screw (#35) left sticking out. Repeat for second Screw (#35)
and U Clip (#22).
Note:
To aid in assembly you can use a cordless drill and
Phillips bit for
Step 9 only
.
Wear safety glasses
.
5.
Lay Table Top (#1) painted side down, on a smooth, flat surface. Use the shipping
container to protect the painted surface of table top.
6.
Align the ”U” Support (#21) on Table Top (#1) as shown in
Figure 5
.
7.
Align all four holes in each U-Clip (#22) with the four Indentations in table top.
Be sure that Slot in the Three U-Clips (#22) all face the same direction toward the
end of the table with no stripe and no Indentations. Secure U-Clips (#22) with
Screws (#5) as shown in
Figure 5
&
Detail A
.
Note:
All four holes in the U-Clip (#22) must align with four Indentations
in table top. See
Detail A
.
If you want to see a video on how to insert Screw (#35) go to:
http://www.escaladesports.com/customer-service/videos.html
Or
Scan with your smartphone:
Detail A
Figure 5
21
22
35
1
Note:
End with no stripe
and no Indentations.
Detail B
5
21
22
Slot in
U-Clip
Note:
All Indentations
guides in table top are
small so look closely.
Note:
Indentations in table top are small so look closely.
