Edition
Manual
Chapter
Page
2008-03-18 Workshop Manual, Stiga Primo
1 General
11
1.6 Raising
Jacks must only be placed in the
designated area. Placing the jack in
other locations will damage the
machine.
The machine must only be raised on
hard, stable and horizontal surfaces.
Otherwise there is a risk of the
machine dropping.
The machine must never be loaded
with further weight when it is raised.
Nobody must sit on the machine when
it is raised.
1.6.1 Raising back
For certain maintenance work, the rear part of
the machine must be raised slightly so that the
required rear wheel can be removed. Raise the
machine as follows:
1. Position the machine on a hard, stable and
horizontal surface.
2. Raise the machine using a jack, see the fig.
1.6.2 Raising front
Note!
To raise the machine at the front, the
cutting deck must be removed.
Raise the machine at the front as follows:
1. Place the machine on a flat, solid and
horisontal ground.
2. Disassemble the cutting deck. See chapter 6.
3. Raise the machine with help of a jack and
apply the yokes according to the figure.
For location of jack and yokes, see the figure.
1
1
2
2