Stiga PARK Royal, Руководство по установке

Страница: 15 / 40

15
ENGLISH
GB
GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
ASSEMBLY
To avoid injury and damage to people
and property, do not use the machine
until all the measures under “ASSEM-
BLY” have been carried out.
ACCESSORIES BAG
The machine is supplied with a plastic bag contain-
ing components which must be installed prior to
use. The bag contains (fig.
1 ):
Pos. No. Designation Dimension
A 1 Sparking plug sleeve
B 1 Torsion pin ditto
D 1 Tension pin 6 x 36
E 1 Shim washer 1 6 x 38 x 0.5
F 1 Shim washer 1 6 x 38 x 1 .0
G 2 Shoulder washer
H 2 Screw 8 x 20
I 2 Knob
J 2 Washer 8.4 x 22 x 1 .5
K 1 Drawing plate
L 2 Screw 8 x 20
M 2 Nut M8
N 2 Screw
ENGINE CASING
To inspect and maintain the engine and battery, re-
move the engine casing. Dismantling:
1 . Unscrew the fuel cap/fuel gauge.
2. Pull up the rubber strap at the front edge of the
casing (fig. 2).
3. Carefully lift off the engine casing (fig. 3).
Assembly:
1 . Place the casing over the lip on each side.
2. Make sure that the pins on the rear edge of the
casing go down into the respective holes (fig. 4).
3. Secure the front edge of the casing with the rub-
ber strap (fig. 2).
4. Finally, screw in the fuel cap/fuel gauge.
BATTERY
The battery is a valve-regulated battery with 1 2 V
nominal voltage. The battery is completely main-
tenance free. You don’t have to check or top up the
electrolyte level.
On delivery, the battery is in the accessories box.
The battery must be fully charged be-
fore being used for the first time. The
battery should always be stored fully
charged. If the battery is stored for
longer than 10 days without being
charged, it can be damaged.
If the machine is not going to be used for an ex-
tended period (more than
1 month), the battery
should be charged, disconnected and then stored in
a cool, safe place. Charge the battery completely
before reinstalling.
The battery can be charged in two ways:
1 . Via a battery charger (recommended). This must
be a charger with constant voltage. The battery
can be damaged if a standard type battery
charger (for acid batteries) is used.
Stiga recommends battery charger with item no.
11 36-0602-0 1 which may be ordered by an au-
thorised dealer.
2. You can also allow the engine to charge the bat-
tery. In this case it is very important, above all
when starting the machine for the first time and
when it has not been used for a long time, to al-
low the engine to run continuously for at least
45 minutes.
Do not short circuit the battery’s termi-
nals. Sparks occur which can result in
fire. Do not wear metal jewellery which
can come into contact with the battery
terminals.
In the event of damage to the battery
casing, cover, terminals or interference
to the strip covering the valves, the bat-
tery should be replaced.
Position the battery in the appropriate place under
the engine casing (fig. 5) and connect the battery
cables.
Note! To avoid damage to the engine and the bat-
tery, the positive battery cable (+) should always
be connected to the battery first.
Do not run the engine when the battery is discon-
nected.