Stiga EL 340 Li 48, Руководство пользователя

Страница: 83 / 254

7
interchangeable and operating safety features
Reassemble the cutting means with the code facing
the ground following the steps indicated in the illustration
Tighten the central screw using a dynamometric key
calibrated at Nm for model or Nm for model
Cleaning the machine
Do not spray water onto the motor and electrical compo
-
nents and prevent them from getting wet
Do not use aggressive liquids to clean the chassis.
BATTERY RECHARGING AND HANDLING
NOTES
The battery must be stored in places with temperatures
between C and C If the machine is stored in
places that could exceed these threshold it is recom
-
mended to remove the battery and store it in a more
suitable location.
During use the battery is protected against total drain
-
age with a protective device that switches o the ma
-
chine and stops it from working
The battery is equipped with a guard that inhibits re
-
charging if the environmental temperature is not be
-
tween and C
The battery can be recharged at any time even partially
with no risk of damaging it
a Checking the battery charge status
To check the condition of the battery charge status
press the small button a which activates four LED lights
b which indicate the following
LED
Battery power reserve
GREEN
100%
GREEN
70%
2 GREEN
1 GREEN 10% - Recharge needed
None
The battery has less than power re
-
serve and needs recharging immediately
If at least one LED does not come on after
minutes charging the battery is faulty and
needs replacing.
b Battery removal and recharging
After every work session the battery should be recharged
To recharge the battery
open the hatch and remove the safety key
press the bottom tab and remove the battery
insert the battery in its housing in the battery charger
pushing it in completely
connect the battery charger to a power socket with the
voltage indicated on the rating plate.
Battery charging lasts from hours depending on
the battery capacity and its residual charge
The battery charger is the diagnostic type tted with a
LED that provides information on the battery and charge
status based on the following chart
LED (5a) Meaning
GREEN
(Flashing
Battery charging
GREEN
Fully charged battery
RED
Battery overheated remove the
battery and leave it to cool for at least
minutes
Off
No battery or battery inserted incor
-
rectly
RED
(Flashing)
Charge anomaly and possible faulty
battery in this case remove the
battery and replace it within hours
if the LED indicates charging status
this means that the battery is in
good condition and the charging can
proceed as normal Otherwise
disconnect the battery charger wait
a few minutes and reconnect it to
the mains again
remove the battery from the
charger wait a few minutes and
replace it again.
If after all these attempts the LED
(5b) does not indicate the charge
status and continues to flash this
means that the battery is faulty and
needs replacing.
c Refitting the battery on the machine
When recharging is completed
press the lower tab and remove the battery do not
keep recharging when recharging is completed
disconnect the battery charger from the mains pow
-
er supply
open the hatch on the machine insert the battery in
its housing on the machine and push in all the way to lock
it into place and ensure electrical contact.
completely close the hatch again
ATTACHMENTS
WARNING
For your safety, it is strictly prohibited
to fit any other attachment other than those included
in the following list, as they have been exclusively de-
signed for the model and type of machine you are using.
Alternative batteries
Di erent capacity batteries are available to suit speci c op
-
erating requirements The list of approved batteries for this
machine is found in the table on page ix
DIAGNOSTICS
What to do if
Problem description
Corrective action
The motor does not start
when the switch is pressed
Safety key is not inserted
or is inserted
incorrectly
Insert the key until you
here it click see