Stiga BIO 2000, Инструкция по эксплуатации, Страница: 9 / 14

ENGLISH
GB
- The material can be placed in an insulated com-
post holder. The heat is then held for longer and
the rotting process also continues during the
winter. This method produces faster results
(warm composting).
- The material can be spread directly onto the
garden (surface composting).
MAINTENANCE
Always disconnect the plug from the
electric socket before any adjustment
and maintenance.
REPLACING BLADES
The blades for the compost grinder have two cut-
ting edges. This means they are reversible.
When both cutting edges have been used, the
blades should be replaced.
When replacing
blades, always use genuine Stiga blades.
Replace the blades as follows:
1. Switch off the motor and pull out the plug. Wait
until the blades have stopped.
2. Undo the locking wheel (fig. 8) and open the
compost grinder.
Always use protective gloves when
changing blades and cleaning the blade
disc.
3. Undo the screws using a screwdriver. There are
holes in the blade disc to simplify this. By
screwing through these holes, you prevent the
blade disc from turning (fig. 11).
4. Turn the blades and install with the sharp edge
facing the cutting direction. Tighten the screws
properly.
If both cutting edges of the blades have already
been used, replace with new genuine blades or
sharpen
SHARPENING THE BLADES
The blades are hardened and may therefore not be
sharpened on a grinding wheel.
Sharpening of the blades must be done by wet
method grinding, using a whetstone or a grind-
stone.
In order to avoid imbalance, the blades must be
ground so that both blades weigh exactly the same
after grinding.
CLEANING
Always clean the compost grinder after each use.
Switch off the motor and pull out the plug. Undo
the locking wheel (fig. 8) and open the compost
grinder. Clean carefully around the blade disc.
Never use water when cleaning the
grinder!
Brush away dirt and plant residue, which could be
caught in the blades.
SERVICE
Authorised service stations carry out repairs and
servicing. They always use genuine spare parts.
See attached list.
Do you carry out basic repairs yourself? If so, be
sure to use genuine spare parts. They fit perfectly
and make the work much easier.
When ordering spare parts, specify the name, item
number and serial number for the machine. This
information can be found on the identification
plate located on the machine.
Under no circumstances may parts oth-
er than genuine spare parts be used.
This is a requirement stipulated by the
Testing Authority. The machine is ap-
proved and tested with these parts.
The manufacturer reserves the right to make alter-
ations to the product without prior notification.
prior notification.