EN - 33
6. Remove hardware retaining drag links to
frame. See Figure 50.
7. Remove hardware retaining deck lift links
to deck lift brackets. See Figure 51.
8. Remove deck from under unit.
Install Deck
1. Position deck under unit.
See Figure 52.
2. Reinstall drag links to frame with original
hardware.
3. Secure deck lift links to deck lift brackets
with original hardware.
4. Reinstall PTO belt. See
5. Reconnect lift-assist springs to spring
pegs.
6. Level the deck. See
LEVEL AND PITCH MOWER
DECK
IMPORTANT:
Make sure unit is on a flat,
level surface and that tyres are inflated to the
recommended pressures.
Check Blade Level and Pitch
1. Raise deck to 3 1/2" (8.9 cm) cutting
height.
2. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool.
3. Engage parking brake.
See Figure 53.
4. Position mower blades so ends point left
to right across the width of the deck.
5. Measure the distance between the
ground and the cutting edge of the left
and right blades. If the measurements are
not within 4.7 mm (3/16") of each other,
level the deck. See
Figure 50
Figure 51
Figure 52
