STIEBEL ELTRON AUK 14, Эксплуатация и установка

Страница: 9 / 22

EN
GL
ISH
WWW.STIEBEL-ELTRON.COM AUK | 29
INSTALLATION
INSTALLATION
9.2 Inspection on delivery
»
Upon receipt, immediately check that the delivery is complete
and without transport damage.
If you notice any transport damage, proceed as follows:
- Do not accept the delivery or only accept it with reservation.
- Note all damage on the delivery documentation or on the
delivery slip of the carrier.
- Initiate a claim.
!
Initiate the claim for damages without delay.
Make a claim for any fault as soon as it is detected.
Claims for damages can only be made within the valid
claim period.
9.3 Handling
CAUTION
Risk of injury through heavy loads
Observe the weight of the appliance. When handling, use
suitable transport aids or sufficient manpower.
!
Damage through incorrect handling
Incorrect handling can lead to material losses. Observe
the information on the packaging. Only remove the
packaging shortly before the installation.
9.4 Installation
26
�03
�1
4�
003
5
Parts of the casing at the l.h. and r.h. side of the appliance can
be pivoted out. Both of these swing doors are secured with two
quarter turn locks.
»
Turn the quarter turn lock by 90° with a screwdriver to release.
»
Pivot the swing doors out to the side.
9.4.1 Pulling out the spring pin
The wall mounting bracket is fixed to the appliance with two spring
pins. This prevents the appliance from falling off the mounting
bracket after installation.
To fix the wall mounting bracket to the wall, it temporarily needs
to be taken off the appliance.
After opening the swing doors, you will see a spring pin located in
the upper part just in front of the back panel. There is one spring
pin on the l.h. and one spring on the r.h. side of the appliance.
26
�0
3�
14
�0
04
7
1
1 Spring pin
»
Pull out the spring pins.
9.4.2 Removing the wall mounting brackets from the appliance
26
�0
3�
14
�0
04
8
1
1 Wall mounting bracket
»
To remove the wall mounting bracket from the back panel
of the appliance, pull it downwards and then away from the
back panel.